Added the ability to fully customize the tooltip, featuring: Font change. The feature has been tested and the time offset between different computers is less than 0.1 seconds. In subsequent chapters, these boundary conditions will be translated into the design of various sub component specifications. The user has the ability to select the period of time that must pass before the clock syncs the time again. Examples of these sub blocks include low-noise amplifiers (LNA), mixers, and intermediate frequency (IF) amplifiers. Next we translate these boundary conditions into boundary conditions of the front end sub blocks. We then adopt specific receiver architecture and translate the boundary conditions imposed by the channel and the demodulator on the front end (specified in Chapter 1 in terms of communication concepts ) to circuit concepts (gain, noise figure, distortion). We first review some general philosophy on deciding the front end architecture. Specifically, in this chapter we discuss the architecture of the front end as well as the filters inside, and in the rest of the book we concentrate on the design of active components inside the front end. In this chapter and the rest of the book, we emphasize this front end part of the communication system. We now redraw Figure 1.1 as Figure 2.1, with the receiver front end enclosed by dotted lines. They are the modulator, demodulator, and channel part of the communication system. In Chapter 1 we focused on the blocks enclosed by dotted lines in Figure 1.1.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |